Contents
Summary
Tools You Will Need
Note Before You Begin
Step-by-Step
Summary
This article will give a detailed overview of installing or replacing the radio board in your SoloVision. The radio board is necessary for the SoloVision and computer to communicate with your 3G Wireless device. The SoloVision holds only one radio at a time. In order to change with which device your SoloVision can communicate, you must first change the radio board.
Tools You Will Need
Phillips head No. 2 screwdriver
Small or Medium Flat-head Screwdriver (only for some, see step 3)
Radio board ready to install (labeled D4, D5, D6, or D7)
SoloVision (D11)
Note Before You Begin
- The SoloVision does not have an AC Power adapter and therefore does NOT need to be plugged into an outlet.
- Do NOT connect the SoloVision to your computer while you are removing or installing the radio.
-The SoloVision comes pre-installed with a radio board to accompany the device you purchased. You do not need to go through these steps if you have just purchased a SoloVision with a specific device.
Step-by-Step:
1. Unscrew the 4 screws on the bottom of the D11 / SoloVision unit, with a No. 2 Phillips head screwdriver.
2. Inside you will find a radio board in the middle of the device; these will be labeled D4 (for ThermoVision), D5 (for FlexVision), D6 (for DynaVision), or D7 (for ScanVision). [CM1] Confirm it is the correct radio board for the device you are removing. replace with the new radio board for the alternate device.
3. You may need to remove a nylon screw (white colored screw) from the current radio board installed in the SoloVision. If so, using a small or medium sized flat-head screwdriver remove the screw.
4. After the screw is removed, firmly grab the sides of the radio board and pull up, apply equal pressure to both sides, some force may be needed to remove the radio board. Pull until the radio board detaches from the main board.
5. Replace with new radio board by aligning the 4 pins on the radio board with the 4 holes on the main board and press the radio board in place.
6. Replace cover and screw in the 4 screws.
7. Plug USB cable in and confirm the ‘Power’ light is lit up and green.