This document has been taken (and then expanded) from the MyoVision User Manuel which is located in your software. To access the full MyoVision User Manuel go to the “Help” drop-down menu and choose “MyoVision User Manuel.”
The PhysioMonitor will need to be plugged into the computer and the wall. The PhysioMonitor should have a green "Computer Connect" light and a green "Power" light. Some of the Active Devices should also show green. If your "Power" or "Computer Connect" light is not green, check the PhysioMonitor's connection with the computer (try a different USB port) and the connection to the wall.
With the PhysioMonitor powered on and connected to the computer, turn on the devices that are to be bound by toggling their power switches. Test that they are on by pressing their respective "Start" buttons and that lights are coming on.
1. Open the MyoVision software.
2. Go to the “Setup” menu, choose the “Settings” submenu, and click on “3G Bind Devices.” This will display the connection status and battery life.
3. Press the Start buttons on the devices in your hand (make sure you have toggled the power switched to the “On” position) they should light up with 1 green light, and 1 blinking red light.
Note: The green light should be the “Power” light.( If it is red, then you will need to put new batteries into the device.) The blinking red light should be the “Connect Status” light.
4. Locate the button that says “Connect Switch.” The "Connect Switch" is locate to the right of the start button on the ScanVision. The "Connect Switch" is located at the top of the dome of the FlexVision. The "Connect Switch" is located on the base of the ThermoVision. The "Connect Switch" is located on the top of the DynaVision.
5. Using a straightened paper clip or push pin, push and hold the recessed “Connect Switch” button on the handheld unit until the red light goes from a blinking red, to a solid red.
Note: If there is a second device, finish the binding process for one unit before proceeding to the second.
|
|
6. While the “Connect Status” LED on the handheld device is a solid red, use the mouse to click on the “Bind” button next to the appropriate device on the “3G Bind Devices” screen.
Note: Make sure to hit the correct Bind button, next to the correct device you have in your hand.
7. When successful, the “Connect Status” LED on the handheld unit should turn green. This “Link Strength” should also change from an empty gray bar to a partially filled bar.
Repeat steps, 3 – 7 for all devices.
Note: The timing of the binding process is crucial. If the handheld device goes back to a blinking red before you hit the “Bind” button you will need to try again. Sometimes, it takes a few tries to get the timing just right to bind the devices.
If you need further assistance please email support@myovision.com with your contact information and a few sentences describing the issue. You can also call 1-800-969-6961, opt 2 for Technical Support.
Are your devices both showing up green in your handheld device, but one is not appearing bound on the screen? Check out this article about possible ways to resolve this issue.