Summary

This document shows you how to pair your SERIES-5 (white label) handheld devices to a computer with a VisionHUB.

Before you begin

1. Make sure you have the latest version of the MyoVision software. Download here: https://www.myovision.com/download
   • How Do I Check My Software Version?
2. Ensure the VisionHUB is plugged into the computer and have each device nearby and the power switch in the ON position
   • Not sure where the power switch is? See our SERIES-5 First Time Setup guide for device overview

How to pair SERIES-5 devices to your computer

1. Check that the software is properly configured

• Go to Setup > Devices > Preferences (or press Control + 1 on the keyboard.)
  • Confirm that the "VisionHUB" option is selected
    • If you have both SERIES-5 and 3G/4G devices see our support article HERE for instructions for a Custom configuration then proceed to Step 2 "Pair your SERIES-5 devices" in this article
  • If the software is not configured correctly:
    • Select the "VisionHUB" option then click "OK"

2. Pair your SERIES-5 devices

1. When you first launch the MyoVision software with the VisionHUB plugged in, a pop-up window will prompt you to begin the pairing process. Click Yes, to go to the pairing window.
   • If do not see the option, close then re-open the software with the VisionHUB plugged in. 
   • If you need to go back to this setting, click Setup > Devices > Pair > Series-5  (or press "control + 5" at the same time on your keyboard).
2. Turn on all devices: Turn the Power Switch into the ON position and press the Start Button on each device
3. Press "Scan for Devices" in the "Pair Series-5 devices...." window.
   • This process can take a few minutes depending on your computer. Your devices will turn off one at a time as they pair.
   • When the pairing process is complete, a pop-up in the lower right corner will appear and each device will say "Paired" next to it.
     • The "Paired" devices will match what devices you own. 
     • If not all of the expected devices paired, turn on all the devices again by clicking the start button and click "Scan for Devices." Below is an example of a DynaROM system with a Single ScanVision.