-
Last Updated: 07/01/2019
in Frequently Asked Questions Summary This support article explains how to enter the calibration values for your Thermography device. Before you begin, make sure that your Thermography device has been setup in software settings. To do this, click on "Setup" at the top of...
-
Last Updated: 05/15/2019
in How do I... DynaROMHow to go back and redo a motion during a DynaROM exam.
-
Last Updated: 07/08/2019
in Hardware IssuesLearn how to troubleshoot when the "Bind" light on your SoloVision is blinking.
-
Last Updated: 07/23/2019
in Software IssuesThis guide will help you troubleshoot, if it seems the MyoVision software is not registering your button presses.
-
Last Updated: 03/01/2018
in Software IssuesComputer requirements for MyoVisoin software
-
Accidentally saved an exam under the wrong patient? Easily move it to the correct one.
-
Last Updated: 10/25/2019
in Frequently Asked QuestionsYes! Find out how by reading this article.
-
How to import your database after upgrading from M8000
-
Turn on Single Inclinometer Mode to perform ROM exams with only one device
-
Last Updated: 07/18/2018
in Hardware Issues If you just updated your software, and now your DynaVision is only displaying channels 1 and 2 (See example below), go through the troubleshooting steps listed. Unplug the lead wires and plug them back in, make sure that they are fully seated insi...